Showing all 7 results

  • Filtre
  • Sorter etter:
  • 249,00 kr inkl. mva

    «The Tinypink is a professional stencil cap which, once attached to the spray can, allows for ultra-fine lines. The spray jet, of just a few millimeters, is much more precise than with any other cap. It is the essential accessory for creating tiny details or for working in very small formats, on canvas for example. The Tinypink Stencil cap differs from the traditional Stencil cap by its paint recovery system. The excess paint no longer flows on the sprayer (and on the hands) or on the floor, the workspace is now clean. It is collected in a dedicated tank and can be reused thanks to the removable cap located at the bottom of the tank. No more waste of paint, the excess can be recycled in a marker or used with a brush for example.»

    AVAILABILITY: In stock

  • -16%
    LIMITED
    225,00 kr inkl. mva

    «All three of our NightQuill actuators (Kryptonite, Aqua, and Infrared) in a discounted 3-pack.»

    AVAILABILITY: In stock

  • 89,00 kr inkl. mva

    «Our Medium Touch ( Aqua ) Actuator retains rigidity in it’s trigger and offers some bounce in it’s characteristic. Our all rounder of the family and great on all valve systems to help avoid strain while offering greater control and half nozzle pressure consistently.»

    AVAILABILITY: In stock

  • 89,00 kr inkl. mva

    «Our Soft Touch ( Infrared ) Actuator has the softest feeling trigger of the family with a lot of built in bounce on the finger tip. This allows you to find the balance point and hold quarter and half nozzle pressure consistently. It is great on a diverse range of nozzles and will help avoid strain. Amazing for fine details, dusting and spitting textures. It’s the airbrush of the range takes stress out of painting while injecting fun.»

    AVAILABILITY: In stock

  • 89,00 kr inkl. mva

    «Our Hard Touch ( Kryptonite ) Actuator has the most rigid trigger of our family, which gives you the greatest leverage over any nozzle. This equates to around half of the pressure applied to depress a nozzle (spray) and is best used to avoid strain while blocking out large areas. Fantastic on hard valve systems and problematic nozzles.»

    AVAILABILITY: In stock

  • 5,00 kr inkl. mva

    Transfer Cap brukes hovedsakelig til å overføre maling fra aerosolen til en beholder (for eksempel en sprayhette). Malingen som dermed er samlet, kan deretter brukes med en børste. Spesielt anbefalt for bruk med MTN Water Based, børstene kan skylles med vann.

    Ellers oppfører denne dysen seg på samme måte som en Ultraskinny / Needle Cap: høy flyt og tynn linje. Når opp til nye høyder.

    Passer på alle MTN spraybokser (unntatt de med «male valve» som f.eks Madmaxxx)

    AVAILABILITY: In stock

  • 39,00 kr inkl. mva

    Tynneste mulige linjer (noen millimeter bare), settes direkte på sprayboksen.
    (Husk å ta av farge-greie / donut rundt boksen) Kan brukes igjen og igjen.

    AVAILABILITY: In stock

Ingen produkter matchet ditt valg.

Navigasjon
Close

Min Handlekurv

Close

Ønskeliste

Godt å se deg her!

Ett passord blir til-sendt deg per epost.

Dine personopplysninger brukes til å øke brukervennligheten på denne nettsiden, gi deg tilgang til administrasjon av din brukerkonto og andre formål som beskrevet i våre personvernregler.

Har du allerede en kundekonto?

Close

Kategorier